REMOTE KEY FOB PROGRAMMING INSTRUCTIONS - PROCEDURES FOR SEAT ALHAMBRA

     REMOTE KEY FOB PROGRAMMING INSTRUCTION - SEQUENCE FOR SEAT ALHAMBRA  

     PRODUCED FROM 1995 TO JULY 1997 WITH INFRARED REMOTE CONTROL :

     Ensure all doors and windows on the vehicle are shut.

     1. Insert key into driver’s door lock.
     2. Turn the key to the unlock position 3 times ( key must be held in open position by 0.5 seconds )
     3. Remove the key.

     The driver’s door LED will illuminate. Within 20 seconds:

     4. Point the key at the receiver located near the rear view mirror.
     5. Press and hold the lock button.
     6. Still pressing the lock button - press the unlock button 3 times.
     7. Release the lock button.

     The driver’s door LED should flash to indicate correct programming.
     Repeat 4 to 7 for additional remotes up to a maximum of four.
     Wait 15 seconds before trying remote.

     ______________________________________________________________________________
     ______________________________________________________________________________ 
 

     REMOTE KEY FOB PROGRAMMING INSTRUCTION - SEQUENCE FOR SEAT ALHAMBRA  

     PRODUCED FROM 1997 TO 1999 WITH RADIO REMOTE CONTROL ( 5FA007680 and others ) :

     Ensure all doors and windows on the vehicle are shut.

     1. Insert key into driver’s door lock.
     2. Turn the key to the unlock position 3 times and keep the key in the lock opening position for 5 sec.
     3. Remove the key.

     The driver’s door LED will illuminate. Within 20 seconds:

     4. Press and hold the lock button.
     5. Still pressing the lock button - press the unlock button 3 times.
     6. Release the lock button.

     The driver’s door LED should flash to indicate correct programming.
     Repeat 4 to 7 for additional remotes up to a maximum of four.
     Wait 15 seconds before trying remote.

     _____________________________________________________________________________ 
     _____________________________________________________________________________

     REMOTE KEY FOB PROGRAMMING PROCEDURE - INSTRUCTION FOR SEAT ALHAMBRA  

     PRODUCED FROM 1999 TO 2002 ( 7M3959753,  7M3959753F and compatible ) :

     1. Open and close the both front windows.
     2. One of the key switch on the ignition and leave the key in this position.
     3. Get out of the car, close the door and i
nsert second key into driver’s door lock.
     4. Turn the key to the unlock position 3 times ( key must be held in open position by 1 seconds ).
     5. Remove the key.

     The driver’s door LED will illuminate. Within 20 seconds:

     6. Press and hold the lock button.
     7. Still pressing the lock button - press the unlock button 3 times.
     8. Release the lock button.
     9. Open the door with the key manually ( not via remote control )

     The driver’s door LED should flash to indicate correct programming.
     Repeat 4 to 7 for additional remotes up to a maximum of four.

     _____________________________________________________________________________
     _____________________________________________________________________________

seat ALHAMBRA remote programming instruction

INFRARED REMOTE CONTROL

SEAT ALHAMBRA 1995-1997

5FA007680 REMOTE CONTROL PROGRAMMING INSTRUCTION

RADIO REMOTE CONTROL
SEAT ALHAMBRA 1997-1999
( 5FA 007 680 and compatible )

Dálkové programování POKYNY SEAT ALHAMBRA INSTRUCTIONS PROGRAMMING KEYS FOBS

RADIO REMOTE CONTROL
SEAT ALHAMBRA from 1999
( 7M3 959 753 and compatible )

   Programming the remote control key fob in Seat Alhambra produced after 2002/2003 it may be impossible without
   the use of diagnostic equipment ( VCDS, VAG Commander, VAS50xx, ODIS and others ). 

 REMOTE KEY FOB PROGRAMMING INSTRUCTIONS - PROCEDURES FOR SEAT ALHAMBRA