PONTIAC BONNEVILLE remote key fob programming instructions

THESE ARE THE STEPS YOU NEED TO FOLLOW IN ORDER TO PROGRAM REMOTE KEY FOB 

IN PONTIAC BONNEVILLE PRODUCED TO 2000. NO TOOLS REQUIRED. 

______________________________________________________________________________


  1. Close all doors.

  2. Insert keys in ignition and leave in the OFF position.

  3. Locate the OBDII Port under drivers side dashboard.

  PONTIAC REMOTE FOB INSTRUCTION - DEALER CAR - PRICE

  4. Make sure there are metal contact pins in terminals 8 and 4.

  Connect 8 and 4 with a suitable jumper wire ( leave jumper wire connected throughout the
  programming procedure ). Make sure you know which terminals are 8 and 4.

  The vehicle will respond by locking and unlocking the doors to signify entering of programming mode.

  5. Turn ignition to the ON position ( as far as you can go without cranking the engine ). 

      Doors will lock.

  6. Press and hold both the LOCK and UNLOCK buttons together on the first remote to be programmed
      up to 30 seconds, the vehicle will respond by locking then unlocking the doors. Release buttons.

  7. Within one minute, repeat step 6 for any additional remotes if any, including existing remotes.

  8. Remove jumper wire from OBDII Port.
__________________________________________________________________________________
 
Remote key fob programming in Pontaic Bonneville produced from 2000 requires a scan tool or other special device like TECH-2 example.There is no manual way to program keyless remotes to this vehicle.

PONTIAC KEY FOB REMOTE KEYLESS PROGRAMMING INSTRUCTION