SEAT INCA - REMOTE TRANSMITTER PROGRAMMING PROCEDURE

REMOTE TRANSMITTER PROGRAMMING PROCEDURE FOR SEAT INCA TO 1999

KEY FOB - REMOTES WITH INFRARED REMOTE CONTROL ONLY ( e.g. 6K0959753B ).

1. Close all windows and doors in the car.
2. Insert the key into driver door lock.
3. Turn the key to the LOCK position and hold in this position 5 seconds.
4. Turn the key from the NEUTRAL to UNLOCK position 3 times ( 0.5 sec in unlock position ).
5. Remove the key from driver door lock. 
    In this moment system is in the remote learning mode.
6. Point the key at the receiver located near the rear view mirror ( ! ).
7. Press and hold the LOCK button in the remote control.
8. STILL PRESSING the LOCK button - press the UNLOCK button 3 times.
9. Release the lock button. LED in the key should flash to indicate learning. 
    If remote key fob have correct programmed - central locking should close.

If you need programming additional remotes - repeat procedure from steep 6 within 10 seconds.
Wait 15 seconds before trying remote.

seat remote trasmitter programming instruction

REMOTE FOB PROGRAMMING GUIDE FOR SEAT INCA PRODUCED TO ABOUT 1999

FOR TRANSMITTER WITH RADIO REMOTE CONTROL ONLY ( e.g. 1M0959753C ).

1. Get into the car and close all doors.
2. Using the car key, switch the ignition lock briefly to ignition lock position 2 and switch off again.
    The switching time must remain under 5 seconds.
    You must insert & turn the key to ignition switch position 2 ( not position 1 )

3. Remove the key from the ignition lock.
4. Press and hold the LOCK button in the remote control.
5. STILL PRESSING the LOCK button - press the UNLOCK button 3 times
6. Release the lock button.
    If remote key fob have correct programmed - central locking should close.

If you need programming additional remotes - repeat procedure from steep 4 within 10 seconds.
Wait 15 seconds before trying remote.

seat 1M0959753C programming guide

REMOTE PROGRAMMING INSTRUCTION FOR SEAT INCA PRODUCED 1999-2002

FOR REMOTE KEY FOB - TRANSMITTER WITH RADIO REMOTE CONTROL ONLY

1. Get into the car and close all doors.
2. Using the car key, switch the ignition lock briefly to ignition lock position 2 and switch off again.
    The switching time must remain under 5 seconds.
    You must insert & turn the key to ignition switch position 2 ( not position 1 )

3. Remove the key from the ignition lock.
4. Press and hold the UNLOCK button in the remote control.
5. STILL PRESSING the UNLOCK button - press the LOCK button 3 times
6. Release the unlock button.
    If remote key fob have correct programmed - central locking should close.

If you need programming additional remotes - repeat procedure from steep 4 within 10 seconds.
Wait 15 seconds before trying remote.

    Programming the remote control key fob in Seat Inca produced after 2003 it may be impossible without the use of diagnostic    

    equipment ( VCDS, VAG Commander, VAS50xx, ODIS etc. ).