Please enable / Bitte aktiviere JavaScript!
Veuillez activer / Por favor activa el Javascript!

MAZDA 6 - REMOTE KEY FOB PROGRAMMING PROCEDURE

REMOTE CONTROL TRANSMITTER PROGRAMMING INSTRUCTION FOR MAZDA 6
THESE INSTRUCTION ARE SUITABLE FOR 2003-2011 MODELS

NO TOOLS REQUIRED. 


MAZDA 6 - REMOTE KEY FOB PROGRAMMING PROCEDURE INSTRUCTION


KEEP IN MIND THAT YOUR CAN PROGRAMM ONLY REMOTES WITH CORRECT FCC / PN FOR YOUR MAZDA 6.
THESE INSTRUCTION WILL WORKS FOR MAZDA 6 WITHOUT KEYLESS ( COMFORT ACCESS ) ONLY.


1. Close all doors in your car, then open the drivers door and leave it open.
2. Insert key into the ignition switch and cycle the ignition to ON and OFF three times;
    Leave the key in the ignition switch.
    The timing is important. You need to complete this steep within 10 seconds.
3. Close and open the drivers door three times.
    When done properly the doors will automatically lock and then unlock. Now the vehicle is in programming mode.
    If locks do not cycle you must start the procedure over.

4. Push the unlock button twice on the first remote to be programmed.
    The door locks will cycle automatically to indicate successful programming.
     If there is only one remote to be programmed to vehicle you must push any button twice again on the same remote,
     wait for locks to cycle, then push any button twice one more time on the same remote
     If there are two remotes to be programmed then press any button on the second remote twice, wait for locks to cycle,
     then push any button twice again on the second remote. To program 3 remotes to this vehicle you must press button
     twice on second remote, wait for locks to cycle, then press any button twice on the third remote.

5. Remove the key from the ignition switch to exit programming mode.
    The ECU will respond a final time with a series ( about 4 ) of door locks and unlocks.
9. Test remote's.

* These instructions will program remote controler ( transmitter ) only.
   If you have the Mazda 6 remote with key (combo), these instructions will only program the remote portion of the fob.
   You will still need to get the transponder key programmed to start your vehicle.


CAR REMOTES PROGRAMMING GUIDES