MAZDA 3 - REMOTE KEY FOB PROGRAMMING INSTRUCTION
REMOTE CONTROL TRANSMITTER PROGRAMMING GUIDE FOR MAZDA 3
NO TOOLS REQUIRED.
THESE INSTRUCTION ARE SUITABLE FOR ABOUT 2003-2012 MODELS WITHOUT SMART ENTRY SYSTEM.
KEEP IN MIND THAT YOUR CAN PROGRAMM ONLY REMOTES WITH CORRECT FCC / PN FOR YOUR MAZDA 3.
|1. Close all doors in your car, then open the drivers door and leave it open.|
|2. Insert key into the ignition and cycle the ignition switch to ON and then OFF three times.|
The timing is important. You need to complete it within 10 seconds.
Leave the key in the ignition switch.
|3. Close and open the drivers door three times.|
When done properly the doors will automatically lock and then unlock. Now the vehicle is in programming mode.
If locks do not cycle you must start the procedure over.
|4. Push the unlock button twice on the first remote to be programmed.|
The door locks will cycle automatically to indicate successful programming.
| If there is only one remote to be programmed to vehicle you must push any button twice again on the same remote,|
wait for locks to cycle, then push any button twice one more time on the same remote
| If there are two remotes to be programmed then press any button on the second remote twice, wait for locks to cycle,|
then push any button twice again on the second remote. To program 3 remotes to this vehicle you must press button
twice on second remote, wait for locks to cycle, then press any button twice on the third remote.
|5. Remove the key from the ignition switch to exit programming mode.|
The ECU will respond a final time with a series ( about 4 ) of door locks and unlocks.
|9. Test remote ( s ).|
* These instructions will program remote controler ( transmitter ) only.
If you have the Mazda 3 remote with key (combo), these instructions will only program the remote portion of the fob.
You will still need to get the transponder key programmed to start your vehicle.