HONDA RIDGELINE - REMOTE KEY FOB PROGRAMMING INSTRUCTION
REMOTE CONTROL TRANSMITTER PROGRAMMING PROCEDURE FOR HONDA RIDGELINE
THESE INSTRUCTION ARE SUITABLE FOR 2006-2014 MODELS
NO TOOLS REQUIRED.
|* Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. |
You must program all existing and new remotes that you wish to use on the vehicle at this time.
|* You must close all doors and the rear liftgate/trunk in order for this programming procedure to work.|
|1. Enter the vehicle and CLOSE ALL DOORS.|
|2. Insert the key into the Ignition Switch.|
I recommend HOLD one remote in your left hand with additional remotes close by.
|3.Turn the Ignition to the ON position, marked “II” on the Ignition.|
The lights on the accessories should come on and the dash will light up.
|4. Within 4 seconds press the LOCK or UNLOCK button on the remote transmitter for approximately 1 second.|
|5. Within 4 seconds turn the Ignition to the OFF position, marked “0” on the Ignition.|
|6. Repeat steep 3, 4 and 5 three times and turn the Ignition to the ON position, marked “II” on the Ignition.|
System should now lock and unlock vehicle to indicate remote programming mode activated
|7. Press the LOCK or UNLOCK button on EACH remote you want to program within 9 seconds.|
Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.
You may program up to three remotes to your vehicle.
|8. Turn the ignition to OFF and pull out the key from ignition switch to exit programming mode.|
|9. Test remote ( s ).|
|IN BRIEF :|
|1. Ignition ON / press button on remote / Ignition OFF |
|2. Ignition ON / press button on remote / Ignition OFF |
|3. Ignition ON / press button on remote / Ignition OFF |
|4. Ignition ON / press button's on each remotes|
|5. Ignition OFF / pull out the key from ignition switch|
* These instructions will program remote controler only.
If you have the Honda Ridgeline remote with key (combo), these instructions will only program the remote portion of the fob.
You will still need to get the transponder key programmed to start your vehicle.