HONDA PRELUDE - REMOTE CONTROL PROGRAMMING INSTRUCTION
REMOTE KEY FOB - KEYLESS ENTRY TRANSMITTER PROGRAMMING GUIDE FOR HONDA PRELUDE
THESE INSTRUCTION ARE SUITABLE FOR 1999-2001 MODELS
FULL PROCEDURE WITHOUT ANY TOOLS REQUIRED.
|* Each of the following steps must be completed within five seconds of one another.|
If you take longer than five seconds between steps or make a mistake, you must start the entire procedure over.
|* Entering the programming mode cancels all learned remotes; So, no one of the previously programmed remotes will work. |
You must reprogram all of the keyless remotes once you are in the programming mode.
|1. Enter the vehicle and CLOSE ALL DOORS.|
|2. Insert the key into the Ignition Switch.|
I recommend HOLD one remote in your left hand with additional remotes close by.
|3.Turn the Ignition to the ON position, marked “II” on the Ignition.|
The lights on the accessories should come on and the dash will light up.
|4. Within 4 seconds press the LOCK or UNLOCK button on the remote transmitter for approximately 1 second.|
|5. Within 4 seconds turn the Ignition to the OFF position, marked “0” on the Ignition.|
|6. Repeat steep 3, 4 and 5 three times and turn the Ignition to the ON position, marked “II” on the Ignition.|
System should now lock and unlock vehicle to indicate remote programming mode activated
|7. Press the LOCK or UNLOCK button on EACH remote you want to program within 9 seconds.|
Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.
You may program up to three remotes to your vehicle.
|8. Turn the ignition to OFF and pull out the key from ignition switch to exit programming mode.|
|9. Test remote ( s ).|
|IN BRIEF :|
|1. Ignition ON / press button on remote / Ignition OFF |
|2. Ignition ON / press button on remote / Ignition OFF |
|3. Ignition ON / press button on remote / Ignition OFF |
|4. Ignition ON / press button's on each remotes|
|5. Ignition OFF / pull out the key from ignition switch|