Please enable / Bitte aktiviere JavaScript!
Veuillez activer / Por favor activa el Javascript!

HONDA JAZZ - REMOTE CONTROL PROGRAMMING INSTRUCTION

REMOTE KEY FOB - KEYLESS ENTRY TRANSMITTER PROGRAMMING GUIDE FOR HONDA JAZZ

NO TOOLS REQUIRED. 


* You must close all doors and the rear liftgate/trunk in order for this programming procedure to work.
* Each of the following steps must be completed within five seconds of one another.
  If you take longer than five seconds between steps or make a mistake, you must start the entire procedure over.


1. Enter the vehicle and CLOSE ALL DOORS.
2. Insert the key into the Ignition.
    I recommend HOLD one remote in your left hand with additional remotes close by.
3.Turn the Ignition to the ON position, marked “II” on the Ignition.
   The lights on the accessories should come on and the dash will light up.
4. Within 4 seconds press the LOCK or UNLOCK button on the remote transmitter for approximately 1 second
5. Within 4 seconds turn the Ignition to the OFF position, marked “0” on the Ignition.
6. Repeat steep 3, 4 and 5 three times and turn the Ignition to the ON position, marked “II” on the Ignition.
    System should now lock and unlock vehicle to indicate remote programming mode activated
7. Press the LOCK or UNLOCK button on EACH remote you want to program within 9 seconds.
    Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.
    You may program up to three remotes to your vehicle.

8. Turn the ignition to OFF and pull out the key from ignition switch to exit programming mode
9. Test remote ( s )

IN BRIEF :
1. Ignition ON / press button on remote / Ignition OFF 
2. Ignition ON / press button on remote / Ignition OFF 
3. Ignition ON / press button on remote / Ignition OFF 
4. Ignition ON / press button's on each remotes
5. Ignition OFF / pull out the key from ignition switch

REMOTE KEY FOB - KEYLESS ENTRY TRANSMITTER PROGRAMMING GUIDE FOR HONDA JAZZ

* These instructions will only program a keyless entry remote.
   If you have the Honda Jazz remote with key ( combo ), these instructions will only program the remote portion of the fob.
   You will still need to get the transponder key programmed to start your vehicle.

CAR REMOTES PROGRAMMING GUIDES