Please enable JavaScript!
Bitte aktiviere JavaScript!
S'il vous plaît activer JavaScript!
Por favor,activa el JavaScript!

CHEVROLET TAHOE :  REMOTE CONTROL TRANSMITTER PROGRAMMING INSTRUCTION

REMOTE KEY FOB  PROGRAMMING PROCEDURE FOR CHEVY TAHOE 1997 - 1999 MODELS

NO TOOLS REQUIRED. 


Remote Control Transmitter programming for Chevrolet Tahoe ( 1997-1999 ) is very simple.

First - you must find Data Link Plug ( Diagnostic Connector, OBD2 Plug ) in your vehicle and follow the instructions below.

 1. Locate the Data Link Connector. It is located under dash drivers side.

 2. Connect pin 8 to pin 4 with a suitable jumper wire. 
     Any short piece of conductive wire will work (i.e. – a paper clip). 
     You will leave the jumper wire connected throughout the programming procedure. 
     The vehicle will respond by locking and unlocking the doors to indicate that the vehicle has entered programming mode.

REMOTE KEY FOB LEARNING PROCEDURE FOR CHEVY TAHOE

 3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed.
     
After about 15 seconds, the vehicle will respond by locking and unlocking the doors.
     Release the buttons on the transmitter.
  4. Within one minute, repeat Step 3 on all additional remotes ( including working ones )
  5. Remove the jumper wire connected to the Data Link Port. 
      Programming is now complete.
* Programming Notes:
Obtain all remote control transmitters for this vehicle. This procedure will erase all previously programmed remotes.
You must program all existing and new remotes that you wish to use on the vehicle at this time.
PN of remote control transmitters for Chevy Tahoe 1997-1999 : AB01502T, ABO1502T, 16245100-29, 16245100-5, 16245105