CHEVROLET TAHOE :  REMOTE CONTROL TRANSMITTER PROGRAMMING INSTRUCTION

REMOTE KEY FOB  LEARNING PROCEDURE FOR CHEVY TAHOE
THESE INSTRUCTION ARE SUITABLE FOR 2007 - 2010 MODELS

NO TOOLS REQUIRED. 


* Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes.
  You must program all existing and new remotes that you wish to use on the vehicle at this time.
* You must close all doors and the rear liftgate/trunk in order for this programming procedure to work.

PN of remote control transmitters : OUC60221, OUC60270, 15913421, 20868672, 22951510, 15913415 and others.


  PROCEDURE #1 
  VEHICLES WITH DRIVER INFORMATION CENTER BUTTON LOCATED TO THE RIGHT OF STEERING WHEEL :


  1. TURN THE IGNITION SWITCH TO THE 'ON' POSITION ( MARKED “II” ON THE IGNITION SWITCH )

  2. PRESS THE VEHICLE INFORMATION BUTTON UNTIL “PRESS TO RELEARN REMOTE KEY” IS DISPLAYED.
  3. PRESS THE SET / RESET BUTTON UNTIL “REMOTE KEY LEARNING ACTIVE” IS DISPLAYED.
      Vehicle is now in Remote Control Transmitters Programming Mode.
  4. PRESS AND HOLD "LOCK" AND "UNLOCK" BUTTONS AT THE SAME TIME ON FIRST REMOTE ( ABOUT 10 SEC ).
      An acoustic signal will sound indicating successful programming.
  5. REPEAT STEP 4 TO PROGRAM ADDITIONAL REMOTES.
      You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.
  7. TURN IGNITION OFF AND REMOVE KEY FROM IGNITION LOCK FOR EXIT REMOTES LEARNING MODE.
  

  PROCEDURE #2
  VEHICLES WITHOUT DRIVER INFORMATION CENTER BUTTON :


  1. TURN THE IGNITION SWITCH TO THE 'ON' POSITION ( MARKED “II” ON THE IGNITION SWITCH )
  2. PRESS THE TRIP ODOMETER RESET BUTTON UNTIL “RELEARN REMOTE KEY” IS DISPLAYED.
  3. PRESS AND HOLD THE TRIP ODOMETER RESET BUTTON FOR APPROXIMATELY 3 SECONDS
      UNTIL “REMOTE KEY LEARNING ACTIVE” DISPLAYS.

      Vehicle is now in Remote Control Transmitters Programming Mode.
  4. PRESS AND HOLD "LOCK" AND "UNLOCK" BUTTONS AT THE SAME TIME ON FIRST REMOTE ( ABOUT 10 SEC ).
      An acoustic signal will sound indicating successful programming.
  5. REPEAT STEP 4 TO PROGRAM ADDITIONAL REMOTES.
      You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.
  7. TURN IGNITION OFF AND REMOVE KEY FROM IGNITION LOCK FOR EXIT REMOTES LEARNING MODE.