CHEVROLET SUBURBAN : REMOTE CONTROL TRANSMITTER PROGRAMMING INSTRUCTION
REMOTE KEY FOB LEARNING PROCEDURE FOR CHEVY SUBURBAN 1996 - 1999 MODELS
NO TOOLS REQUIRED.
Remote Control Transmitter programming for Chevrolet Suburban ( 1996-1999 ) is very simple.
First - you must find Data Link Plug ( Diagnostic Connector, OBD2 Plug ) in your vehicle and follow the instructions below.
1. Locate the Data Link Connector. It is located under dash drivers side.
| 2. Connect pin 8 to pin 4 with a suitable jumper wire. |
Any short piece of conductive wire will work (i.e. – a paper clip).
You will leave the jumper wire connected throughout the programming procedure.
The vehicle will respond by locking and unlocking the doors to indicate that the vehicle has entered programming mode.
| 3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. |
After about 15 seconds, the vehicle will respond by locking and unlocking the doors.
Release the buttons on the transmitter.
|4. Within one minute, repeat Step 3 on all additional remotes ( including working ones )|
| 5. Remove the jumper wire connected to the Data Link Port. |
Programming is now complete.