CHEVROLET SILVERADO :  REMOTE CONTROL TRANSMITTER PROGRAMMING INSTRUCTION

REMOTE CONTROL KEY FOB LEARNING PROCEDURE FOR CHEVY SILVERADO 2000 - 2006 MODELS

NO TOOLS REQUIRED. 


* Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes.
  You must program all existing and new remotes that you wish to use on the vehicle at this time.
* You must close all doors and the rear liftgate/trunk in order for this programming procedure to work.

PN of remote control transmitters : LHJ011, 21997127, 15132197, 15132198, 15186200, 15186201, 10377295, 15186203

CHEVROLET SILVERADO : REMOTE CONTROL TRANSMITTER PROGRAMMING INSTRUCTION

        remote control transmitters : LHJ011, 21997127, 15132197, 15132198, 15186200, 15186201, 10377295, 15186203


  1. ENTER THE CAR AND CLOSE ALL DOORS.
  2. INSERT THE KEY INTO THE IGNITION SWITCH.
  3PRESS AND HOLD THE POWER UNLOCK BUTTON ON DRIVER’S SIDE DOOR PANEL.
      DO NOT release until instructed to do so in Step 8.

  4. TURN THE IGNITION TO THE ON POSITION, MARKED “II” ON THE IGNITION.
  5. TURN THE IGNITION TO THE OFF POSITION, MARKED “0” ON THE IGNITION.
  6. TURN THE IGNITION TO THE ON POSITION, MARKED “II” ON THE IGNITION.
  7. TURN THE IGNITION TO THE OFF POSITION, MARKED “0” ON THE IGNITION.
  8. RELEASE THE POWER UNLOCK BUTTON ON THE DOOR PANEL.
     The vehicle will lock and unlock the doors automatically to confirm remote programing or learning mode.
  9. HOLD DOWN THE LOCK AND UNLOCK BUTTONS ON THE REMOTE TRANSMITTER SIMULTANEOUSLY
      UNTIL THE DOOR LOCKS AND UNLOCKS.
10HOLD DOWN THE LOCK AND UNLOCK BUTTONS ON THE REMOTE TRANSMITTER SIMULTANEOUSLY 
      UNTIL THE DOOR LOCKS AND UNLOCKS.

11REPEAT THE PREVIOUS STEP FOR EACH ADDITIONAL CAR TRANSMITTER
      ( INCLUDING ANY EXISTING REMOTE TRANSMITTERS ).

12TURN THE IGNITION TO THE "ON" POSITION, MARKED “II” ON THE IGNITION  IN ORDER TO EXIT
      THE REMOTE CONTROL TRANSMITTER PROGRAMMING MODE.